Squat Stand Assembly

Squat Stand Assembly Instructions:

** To avoid injury, always have assistance from someone while assembling this product

• Lay the equipment down on a flat surface – if the surface is not flat and level, this product will not be safe to use or assemble
• Set the uprights aside. Lay the two mounting beams on each side of the crossbar, on the floor
• The bolts should go from the outside to the inside, with the large washer on the outside, and the lock washer and bolt towards the inside – this goes for all hardware on this unit. Finger tighten the two side floor beams, to the crossbar
• With assistance, erect the first upright on the middle of the side floor beam. Use two triangles to match the bolt-spaces, and attach the bolt, washer, lock washer and nut to each space. Finger tighten – do not tighten fully – complete this for each side

If your unit has a pull-up bar: Use the remaining hardware to bolt the pullup bar to the top of the uprights – finger tighten only

• Use a wrench to fully tighten all bolts

 

(Photo below: 72” model for reference)